|Red Hat Cluster Suite: Configuring and Managing a Cluster|
|Prev||Chapter 9. Setting Up a Red Hat Enterprise Linux LVS Cluster||Next|
After determining which of the above routing methods to use, the hardware for the LVS cluster should be linked together on the network.
The adapter devices on the LVS routers must be configured to access the same networks. For instance if eth0 connects to public network and eth1 connects to the private network, then these same devices on the backup LVS router must connect to the same networks.
Also the gateway listed in the first interface to come up at boot time is added to the routing table and subsequent gateways listed in other interfaces are ignored. This is especially important to consider when configuring the real servers.
After physically connecting together the cluster hardware, configure the network interfaces on the primary and backup LVS routers. This can be done using a graphical application such as system-config-network or by editing the network scripts manually. For more information about adding devices using system-config-network, see the chapter titled Network Configuration in the Red Hat Enterprise Linux System Administration Guide. For more information on editing network scripts by hand, see the chapter titled Network Scripts in the Red Hat Enterprise Linux Reference Guide. For the remainder of the chapter, example alterations to network interfaces are made either manually or through the Piranha Configuration Tool.
Configure the real IP addresses for both the public and private networks on the LVS routers before attempting to configure the cluster using the Piranha Configuration Tool. The sections on each topography give example network addresses, but the actual network addresses are needed. Below are some useful commands for bringing up network interfaces or checking their status.
The best way to bring up any real network interface is to use the following commands as root replacing N with the number corresponding to the interface (eth0 and eth1):
Do not use the ifup scripts to bring up any floating IP addresses you may configure using Piranha Configuration Tool (eth0:1 or eth1:1). Use the service command to start pulse instead (see Section 10.8 Starting the Cluster for details).
To bring a network interface down, type the following command:
Again, replace N in the above command with the number corresponding to the interface you wish to bring down.
If you need to check which network interfaces are up at any given time, type the following:
To view the routing table for a machine, issue the following command: